mpunch Lowers the unload table, then instructs the user to put a plate on the table and press the load button. The plate is punched, then the user is instructed to remove the plate. Command line parameters specify the plate dimensions, plus the punch configuration (0..19). If plate dimensions are not specified on the command line, plate information is taken from state bay 1. Prompts for approval if unload table is busy. Trendsetter_400/800_Auto mpunch <msz> <ssz> <pcfg> Only available with firmware V1.40 and higher.

NVS:

../nvs/al_cfg_pi.xmlNVS: al pi

NVS:

../nvs/media_cal_pcfg.xmlNVS: media pcfg

..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:39:06 2008 PST